August 12, 2005
On the top side of the steering box there should be a hex key adjuster with a nut that tightens it to the case. To make an adjustment you have to use both wrenchs at the same time. Insert the box end wrench on the nut and then insert the hex key into the adjustment "screw". Hold the screw so it doesn't turn when you loosen the nut, then tighten the "play" by turning the screw clockwise then retighten the nut to secure. A little bit goes a long ways since you are adjusting the mesh of the worm gear into the steering box. If you tighten it to tight, it will not let the steering wheel return to the center position by itself when you turn a corner and let go of the wheel. I'm not sure on the Ramchargers if you get at that from under the hood or if you have to crawl under it to get to the steering box.
Hope I explained that adequately...